Skip to main content

What Is Autofill?

V
Written by Veryable Support

Autofill is an advanced algorithm that will accept Bids on your behalf, based on the criteria you set. It will also attempt to Backfill your Op if you have withdrawals before the Op start time.

Autofill Options

Accept Qualified Operators Immediately

Accepts Operators that meet your criteria automatically once a Bid is submitted

Experience Required

Operator must have completed 5 Ops with a 4-star rating or higher in the Op skill you are posting for

Max Bid Allowed

Does not accept Bids over the maximum allowed amount

Lowest Rating Allowed

The minimum Operator rating allowed for Bid acceptance

Lowest Operator Reliability Allowed

The minimum Operator reliability allowed for Bid acceptance

Percent of YLP Bids Accepted

This is the desired percentage of Labor Pool Operators you would like to have in your Op. If the desired percentage cannot be reached, the Op will be filled with the best available non-YLP Operators.

Start Autofill __ Hours Before Op

Indicate the number of hours before the Op start time for Autofill to begin accepting bids

Helpful Tip: Use the Autofill options strategically. Keep in mind that too many criteria can limit the number of Operators accepted into your Op. Autofill does not guarantee fulfillment of your Op.

Basic Autofill Logic

  • Autofill logic assigns a Weighted Autofill Score to Operators which takes into account their Rating, Reliability, Completed ops, and Distance from the Op. Bidding Operators with the highest scores above the minimum criteria will automatically be accepted into the Op until it is fulfilled. If you have your own criteria set, only Operators who pass that criteria will be considered; quality filters always supersede Autofill logic.

  • In the event that an Operator withdraws 4 hours or less before the Op start time, Autofill will attempt to fill the open spot by notifying the remaining unexpired Operator Bids. The first Operator to confirm their attendance will be accepted. If you set any criteria, the invites will only go to Operators who meet that criteria.

Did this answer your question?